MHuiG

「看庭前花开花落,望天上云卷云舒」

实现 VLAN 间通信

# 实现 VLAN 间通信

## 使用路由器物理接口

R1

    <Huawei>sy
    [Huawei]sy R1
    [R1]int g0/0/0
    [R1-GigabitEthernet0/0/0]ip add 192.168.1.254 24
    [R1-GigabitEthernet0/0/0]int g0/0/1
    [R1-GigabitEthernet0/0/1]ip add 192.168.2.254 24
    [R1-GigabitEthernet0/0/1]

SW1

    <Huawei>sy
    [Huawei]sy SW1
    [SW1]vlan batch 10 20
    [SW1]interface g0/0/1
    [SW1-GigabitEthernet0/0/1]p l a
    [SW1-GigabitEthernet0/0/1]p d vlan 10
    [SW1-GigabitEthernet0/0/1]int g0/0/2
    [SW1-GigabitEthernet0/0/2]
    [SW1-GigabitEthernet0/0/2]p l a
    [SW1-GigabitEthernet0/0/2]p d vlan 10
    [SW1-GigabitEthernet0/0/2]int g0/0/3
    [SW1-GigabitEthernet0/0/3]p l a
    [SW1-GigabitEthernet0/0/3]p d vlan 20
    [SW1-GigabitEthernet0/0/3]
    [SW1-GigabitEthernet0/0/3]int g0/0/4
    [SW1-GigabitEthernet0/0/4]p l a
    [SW1-GigabitEthernet0/0/4]p d vlan 20
    [SW1-GigabitEthernet0/0/4]

## 子接口 单臂路由

单臂路由
子接口:

路由器共用一个物理接口，是路由器上的虚拟接口，多个子接口可以共用一个物理接口，每个子接口属于一个单独的网络，每个子接口可以和同一个 VLAN 的设备通信，通过 dot.1q (802.1q) 的标签区分不同子接口的数据，连接子接口的交换机需要使用 Trunk 端口.

R1

    [R1]int g0/0/1
    [R1-GigabitEthernet0/0/1]undo ip add 192.168.2.254 24
    [R1-GigabitEthernet0/0/1]q
    [R1]int g0/0/0
    [R1-GigabitEthernet0/0/0]undo ip add 192.168.1.254 24
    [R1-GigabitEthernet0/0/1]q
    [R1]int g0/0/0.?
      <1-4096>  GigabitEthernet interface subinterface number
    [R1]int g0/0/0.10
    [R1-GigabitEthernet0/0/0.10]dot1q termination vid 10
    [R1-GigabitEthernet0/0/0]int g0/0/0.10
    [R1-GigabitEthernet0/0/0.10]ip add 192.168.1.254 24
    [R1-GigabitEthernet0/0/0.10]arp broadcast enable
    [R1-GigabitEthernet0/0/0.10]int g0/0/0.20
    [R1-GigabitEthernet0/0/0.20]dot1q termination vid 20
    [R1-GigabitEthernet0/0/0.20]ip add 192.168.2.254 24
    [R1-GigabitEthernet0/0/0.20]arp broadcast enable
    <R1>dis cu
    #
     sysname R1
    #
    interface GigabitEthernet0/0/0
    #
    interface GigabitEthernet0/0/0.10
     dot1q termination vid 10
     ip address 192.168.1.254 255.255.255.0
     arp broadcast enable
    #
    interface GigabitEthernet0/0/0.20
     dot1q termination vid 20
     ip address 192.168.2.254 255.255.255.0
     arp broadcast enable
    #

SW1

    [SW1-GigabitEthernet0/0/1]int g0/0/1
    [SW1-GigabitEthernet0/0/1]undo port default vlan
    [SW1-GigabitEthernet0/0/1]undo port link-type
    [SW1-GigabitEthernet0/0/1]int g0/0/2
    [SW1-GigabitEthernet0/0/2]undo port default vlan
    [SW1-GigabitEthernet0/0/2]undo port link-type
    [SW1-GigabitEthernet0/0/2]int g0/0/3
    [SW1-GigabitEthernet0/0/3]undo port default vlan
    [SW1-GigabitEthernet0/0/3]undo port link-type
    [SW1-GigabitEthernet0/0/3]int g0/0/4
    [SW1-GigabitEthernet0/0/4]undo port default vlan
    [SW1-GigabitEthernet0/0/4]undo port link-type
    [SW1-GigabitEthernet0/0/4]
    [SW1-GigabitEthernet0/0/4]int g0/0/1
    [SW1-GigabitEthernet0/0/1]port link-type trunk
    [SW1-GigabitEthernet0/0/1]port trunk allow-pass vlan 10 20
    [SW1-GigabitEthernet0/0/1]int g0/0/2
    [SW1-GigabitEthernet0/0/2]port link-type access
    [SW1-GigabitEthernet0/0/2]port default vlan 10
    [SW1-GigabitEthernet0/0/2]int g0/0/3
    [SW1-GigabitEthernet0/0/3]port link-type access
    [SW1-GigabitEthernet0/0/3]port default vlan 20
    <SW1>dis cu
    #
    sysname SW1
    #
    vlan batch 10 20
    #
    interface GigabitEthernet0/0/1
     port link-type trunk
     port trunk allow-pass vlan 10 20
    #
    interface GigabitEthernet0/0/2
     port link-type access
     port default vlan 10
    #
    interface GigabitEthernet0/0/3
     port link-type access
     port default vlan 20
    #

## SVI 接口 三层交换机 vlanif

三层交换

SVI 接口：交换机虚拟接口，只逻辑存在，每一个 SVI 接口对应一个 VLAN, 可以配置 IP 地址，可以和 VLAN 内设备通信，并且可以生成路由信息，实现基本路由功能.

SW2

    [SW2]vlan batch 10 20
    [SW2]int g0/0/1
    [SW2-GigabitEthernet0/0/1]p l a
    [SW2-GigabitEthernet0/0/1]p d vlan 10
    [SW2-GigabitEthernet0/0/1]int g0/0/2
    [SW2-GigabitEthernet0/0/2]p l a
    [SW2-GigabitEthernet0/0/2]p d vlan 20
    [SW2]int Vlanif 10
    [SW2-Vlanif10]ip add 192.168.1.254 24
    [SW2-Vlanif10]int vlanif 20
    [SW2-Vlanif20]ip add 192.168.2.254 24
    [SW2-Vlanif20]dis cu
    #
    sysname SW2
    #
    vlan batch 10 20
    #
    interface Vlanif1
    #
    interface Vlanif10
     ip address 192.168.1.254 255.255.255.0
    #
    interface Vlanif20
     ip address 192.168.2.254 255.255.255.0
    #
    interface MEth0/0/1
    #
    interface GigabitEthernet0/0/1
     port link-type access
     port default vlan 10
    #
    interface GigabitEthernet0/0/2
     port link-type access
     port default vlan 20
    #

## 应用场景

单臂路由适用于小型企业网或特殊网络.

大中型企业网一般使用三层交换实现局域网内部通信.

## 多层交换机和路由器的区别

多层交换机具备一定的基础路由功能，可以在某些场景下代替路由器。但交换机的功能相对单一，路由器可以实现不同协议之间的数据转发.

一般三层交换机不支持 NAT, 所以在企业网边缘需要路由器或防火墙.

三层交换机一般用于企业内部数据转发以及控制.

路由器一般用于企业边界数据转发.

## 单臂路由 - 三层交换机 - DHCP

SW1

    #
    sysname SW1
    #
    vlan batch 10 to 30
    #
    interface GigabitEthernet0/0/1
     port link-type trunk
     port trunk allow-pass vlan 10 20
    #
    interface GigabitEthernet0/0/2
     port link-type access
     port default vlan 10
    #
    interface GigabitEthernet0/0/3
     port link-type access
     port default vlan 20
    #

R1

    #
     sysname R1
    #
    dhcp enable
    #
    ip pool PC
     gateway-list 30.1.1.254
     network 30.1.1.0 mask 255.255.255.0
     lease day 0 hour 0 minute 10
     dns-list 114.114.114.114
    #
    interface GigabitEthernet0/0/0
    #
    interface GigabitEthernet0/0/0.10
     dot1q termination vid 10
     ip address 10.1.1.254 255.255.255.0
     arp broadcast enable
     dhcp select interface
     dhcp server lease day 0 hour 0 minute 30
     dhcp server dns-list 114.114.114.114
    #
    interface GigabitEthernet0/0/0.20
     dot1q termination vid 20
     ip address 20.1.1.254 255.255.255.0
     arp broadcast enable
     dhcp select interface
     dhcp server lease day 0 hour 0 minute 30
     dhcp server dns-list 114.114.114.114
    #
    interface GigabitEthernet0/0/1
     ip address 12.1.1.1 255.255.255.0
     dhcp select global
    #
    #
    ip route-static 30.1.1.0 255.255.255.0 12.1.1.2
    #

SW2

    #
    sysname SW2
    #
    vlan batch 10 to 30
    #
    dhcp enable
    #
    #
    interface Vlanif12
     ip address 12.1.1.2 255.255.255.0
    #
    interface Vlanif30
     ip address 30.1.1.254 255.255.255.0
     dhcp select relay
     dhcp relay server-ip 12.1.1.1
    #
    interface GigabitEthernet0/0/1
     port link-type access
     port default vlan 12
    #
    interface GigabitEthernet0/0/2
     port link-type access
     port default vlan 30
    #
    interface GigabitEthernet0/0/3
     port link-type access
     port default vlan 30
    #
    #
    ip route-static 0.0.0.0 0.0.0.0 12.1.1.1
    #

远程登录

远程登录 远程登录 telnet 线路认证[R2]telnet server enable // 开启Telent服务[R2]user-interface vty 0 4 // 进入...

OSPF基础

OSPF 基础 OSPF 基础 动态路由AS (自治系统): 由同一个技术机构进行管理并且运行相同的路由选路策略的一组路由器. 动态路由分类按照使用范围分类: IGP: 内部网...

推荐阅读
VLAN原理与配置 以太网链路聚合 OSPF基础 IP路由基础 DHCP VRF 虚拟路由转发

留言区

Notes
数据通信网络
<pjax>
</pjax>
<pjax></pjax>
<pjax> Are You A Robot?</pjax>